| CVE-2026-74934 | Site isolation issue in the Graphics: CanvasWebGL component. This vulnerability was fixed in Firefox 154, Firefox ESR 115.39, Firefox ESR 140.14, Firefox ESR 153.1, Thunderbird 154, Thunderbird 140.14, and Thunderbird 153.1. | 2026-08-18 |
| CVE-2026-74684 | In the Linux kernel, the following vulnerability has been resolved:
net: tap: set skb->dev before parsing virtio net header in tap_get_user_xdp()
The commit 4f61f133f354 ("net: tap: NULL pointer derefence in
dev_parse_header_protocol when skb->dev is null") fixed a crash in
tap_get_user() by assigning skb->dev before calling tun_vnet_hdr_to_skb().
This is required because virtio_net_hdr_to_skb() may invoke
dev_parse_header_protocol(), which dereferences skb->dev. Without the
assignment, a NULL pointer dereference can occur.
However, tap_get_user_xdp() still parses the virtio-net header before
assigning skb->dev. When the vhost TX path passes an XDP buffer containing
a GSO virtio-net header but the protocol is set to zero on purpose,
tun_vnet_hdr_to_skb() can reach dev_parse_header_protocol() while skb->dev
is still NULL, resulting in a crash.
Fix this by looking up the tap device and assigning skb->dev before calling
tun_vnet_hdr_to_skb(), matching the ordering already used in
tap_get_user(). Preserve the existing RCU read-side critical section across
dev_queue_xmit(). | 2026-08-22 |
| CVE-2026-74581 | In the Linux kernel, the following vulnerability has been resolved:
net: ipv6: clear suppressed fib6 rule result
fib6_rule_suppress() drops a suppressed route with ip6_rt_put_flags(),
but leaves res->rt6 pointing at the released rt6_info.
If no later rule supplies a replacement, fib6_rule_lookup() still sees
res.rt6 and returns that stale dst to its caller. A suppressing rule can
therefore leak a released route back to rt6_lookup(), and the next put
hits rcuref_put_slowpath() from dst_release().
Clear res->rt6 when suppressing the route so suppressed lookups fall
through to the null dst instead of reusing the released one. | 2026-08-21 |
| CVE-2026-73434 | A flaw was found in GStreamer gst-plugins-good (avidemux). In gst_avi_demux_riff_parse_vprp(), the number of available gst_riff_vprp_video_field_desc entries is calculated by dividing the remaining buffer size by the attacker-controlled vprp->fields value, rather than by sizeof(gst_riff_vprp_video_field_desc). This can cause the parser to treat more field descriptors as available than fit in the input buffer, resulting in out-of-bounds reads. Processing a crafted AVI via playbin/decodebin can crash the application (denial of service). Fixed upstream in gst-plugins-good 1.28.6 (GStreamer-SA-2026-0072). | 2026-08-12 |
| CVE-2026-73433 | A flaw was found in GStreamer gst-plugins-good (avidemux). When parsing FUJIFILM metadata in an AVI strd chunk, gst_avi_demux_parse_strd() decrements a remaining-length counter by fixed offsets (98 and 10 bytes) without verifying sufficient data remains. For crafted strd payloads of exactly 106 or 107 bytes, the counter underflows to a very large unsigned value, causing subsequent null-terminated string scanning to read far beyond the allocated heap buffer. Date-format normalization may also write beyond the buffer end. Confirmed impacts include heap out-of-bounds read, out-of-bounds write, heap information disclosure (adjacent data appearing in parsed metadata), and application crash/denial of service. The avidemux element is auto-plugged by playbin, decodebin, and gst-discoverer, so opening or previewing a crafted AVI is sufficient to trigger the issue. Fixed upstream in gst-plugins-good 1.28.6 (GStreamer-SA-2026-0072). | 2026-08-12 |
| CVE-2026-73242 | FreeRDP is a free implementation of the Remote Desktop Protocol. Prior to 3.30.0, FreeRDP's winpr/libwinpr/sspi/Kerberos/kerberos.c kerberos_DecryptMessage function fails to bound the peer-controlled GSS Wrap-token EC field before using it with RRC in IOV pointer offsets, allowing a malicious RDP peer to trigger out-of-bounds reads and in-place writes during CredSSP/NLA Kerberos decryption. This issue is fixed in version 3.30.0. | 2026-08-11 |
| CVE-2026-73241 | FreeRDP is a free implementation of the Remote Desktop Protocol. Prior to 3.30.0, FreeRDP server-side RDSTLS in libfreerdp/core/rdstls.c accepts an attacker-supplied RDSTLS_TYPE_CAPABILITIES PDU while rdstls_server_authenticate is waiting for RDSTLS_TYPE_AUTHREQ, leaving resultCode at RDSTLS_RESULT_SUCCESS and allowing a remote unauthenticated client to bypass the RedirectionGuid, username, domain, or password checks. This issue is fixed in version 3.30.0. | 2026-08-11 |
| CVE-2026-72694 | A flaw was found in MRTG. When the MRTG daemon is started as a root user and subsequently drops privileges, a local, low-privileged attacker can exploit a symbolic link (symlink) following vulnerability. By influencing or pre-placing a symlink in the process ID (PID) file path, the attacker can trick the root process into changing the ownership of an arbitrary existing file to the daemon user. This can lead to local privilege escalation, allowing unauthorized access to or modification of sensitive files. | 2026-08-11 |
| CVE-2026-72693 | `openvt -u` is intended to identify the owner of the current VT and then execute `login` as that user from a privileged context. In the documented `kbrequest`/init usage, the ownership test in `authenticate_user()` relies on `stat("/proc/<pid>/fd/0")`. `stat()` on `/proc/<pid>/fd/0` follows the symlink to the underlying TTY device node. As a result, `buf.st_uid` reflects the owner of the TTY node rather than the owner of the process holding the file descriptor. If the TTY owner returns to `root` or the getty owner after logout while an unprivileged process still has `fd 0` attached to that TTY, the check can incorrectly treat that process as belonging to the privileged console owner. Once that check succeeds, the `-u` path executes a passwordless login as the selected user. In the documented `kbrequest`/init deployment using `openvt -us`, this can result in passwordless `login -f root` on the spawned VT. This report establishes that privilege escalation path for that documented deployment; it does not claim equivalent reachability for deployments that do not use `openvt -u` from a privileged `kbrequest`/init path. | 2026-08-11 |
| CVE-2026-72130 | In the Linux kernel, the following vulnerability has been resolved:
nvmet-auth: reject short AUTH_RECEIVE buffers
nvmet_execute_auth_receive() trusts the AUTH_RECEIVE allocation length
after checking only that it is nonzero and matches the transfer length.
In the SUCCESS1 and FAILURE1/default states, that lets a remote NVMe-oF
initiator reach the fixed-size DH-HMAC-CHAP response builders with a
kmalloc() buffer shorter than the response, so nvmet_auth_success1() and
nvmet_auth_failure1() write past the allocation; both only WARN_ON the
short length and then format the message anyway.
Impact: A remote NVMe-oF initiator with access to an auth-enabled target
can trigger a 16-byte heap out-of-bounds write via a one-byte
AUTH_RECEIVE allocation length.
Compute the minimum response length for the current DH-HMAC-CHAP step in
nvmet_auth_receive_data_len() and report a zero data length when the
host-supplied allocation length is shorter, so the existing zero-length
check in nvmet_execute_auth_receive() rejects the command before any
builder runs. The SUCCESS1 minimum is sizeof(struct
nvmf_auth_dhchap_success1_data) plus the HMAC hash length, because the
response hash is written into the rval[] flexible-array tail, so the
minimum is state dependent rather than a flat sizeof. CHALLENGE keeps its
existing variable-length guard in nvmet_auth_challenge().
This is reachable only when in-band DH-HMAC-CHAP authentication is
configured on the target. | 2026-08-15 |
| CVE-2026-72069 | In the Linux kernel, the following vulnerability has been resolved:
locking/rt: Fix the incorrect RCU protection in rt_spin_unlock()
rt_spin_unlock() releases the RCU protection before unlocking the
lock. That opens the door for the following UAF scenario:
T1 T2
spin_lock(&p->lock); rcu_read_lock();
invalidate(p); p = rcu_dereference(ptr);
rcu_assign_pointer(ptr, NULL); if (!p) return;
spin_unlock(&p->lock); spin_lock(&p->lock)
lock(&lock->lock);
rcu_read_lock();
kfree_rcu(p); rcu_read_unlock();
....
spin_unlock(&p->lock)
rcu_read_unlock(); // Ends grace period
rcu_do_batch()
kfree(p);
UAF -> rt_mutex_cmpxchg_release(&lock->lock...)
Regular spinlocks keep preemption disabled accross the unlock operation,
which provides full RCU protection, but the RT substitution fails to
resemble that. Same applies for the rwlock substitution.
Move the rcu_read_unlock() invocation past the unlock operations to match
the non-RT semantics. This makes it asymmetric vs. rt_xxx_lock(), but
that's harmless as the caller needs to hold RCU read lock across the lock
operation. The migrate_enable() call stays before the unlock operation
because there is no per CPU operation in the unlock path which would
require migration to be kept disabled. | 2026-08-15 |
| CVE-2026-71217 | A flaw was found in iperf3. A remote attacker can exploit this vulnerability by sending crafted control-channel JSON with oversized numeric parameters, such as `parallel` and `len`, which are not properly validated by the server. This improper input validation can lead to excessive stream and thread creation, as well as large buffer allocations, causing resource exhaustion. Consequently, this can result in a Denial of Service (DoS) on the affected iperf3 server. | 2026-08-11 |
| CVE-2026-70907 | Vulnerability in the Oracle Java SE, Oracle GraalVM for JDK, Oracle GraalVM Enterprise Edition product of Oracle Java SE (component: JSSE). Supported versions that are affected are Oracle Java SE: 8u501, 11.0.32, 17.0.20, 21.0.12, 25.0.4, 26.0.2; Oracle GraalVM for JDK: 17.0.20 and 21.0.12; Oracle GraalVM Enterprise Edition: 21.3.19. Easily exploitable vulnerability allows unauthenticated attacker with network access via TLS to compromise Oracle Java SE, Oracle GraalVM for JDK, Oracle GraalVM Enterprise Edition. Successful attacks of this vulnerability can result in unauthorized ability to cause a partial denial of service (partial DOS) of Oracle Java SE, Oracle GraalVM for JDK, Oracle GraalVM Enterprise Edition. Note: This vulnerability can only be exploited by supplying data to APIs in the specified Component without using Untrusted Java Web Start applications or Untrusted Java applets, such as through a web service. CVSS 3.1 Base Score 5.3 (Availability impacts). CVSS Vector: (CVSS:3.1/AV:N/AC:L/PR:N/UI:N/S:U/C:N/I:N/A:L). | 2026-08-18 |
| CVE-2026-70906 | Vulnerability in Oracle Java SE (component: 2D). Supported versions that are affected are Oracle Java SE: 25.0.4 and 26.0.2. Easily exploitable vulnerability allows unauthenticated attacker with network access via multiple protocols to compromise Oracle Java SE. Successful attacks of this vulnerability can result in unauthorized ability to cause a hang or frequently repeatable crash (complete DOS) of Oracle Java SE. Note: This vulnerability can be exploited by using APIs in the specified Component, e.g., through a web service which supplies data to the APIs. This vulnerability also applies to Java deployments, typically in clients running sandboxed Java Web Start applications or sandboxed Java applets, that load and run untrusted code (e.g., code that comes from the internet) and rely on the Java sandbox for security. CVSS 3.1 Base Score 7.5 (Availability impacts). CVSS Vector: (CVSS:3.1/AV:N/AC:L/PR:N/UI:N/S:U/C:N/I:N/A:H). | 2026-08-18 |
| CVE-2026-69192 | ip-address is a library for parsing and manipulating IPv4 and IPv6 addresses in JavaScript. Prior to 10.3.1, Address4 accepts an octet written with a leading zero and decodes it as decimal, while the WHATWG URL host parser, inet_aton, and getaddrinfo all decode a leading zero as octal. The library and the network stack therefore disagree about which host a string names. new Address4('012.0.0.1') reports correctForm() of 12.0.0.1 and isPrivate() of false, but fetch('http://012.0.0.1/') connects to 10.0.0.1. An application that builds a network trust-boundary decision on these checks, for example a filter intended to block Server-Side Request Forgery, or SSRF, will classify an internal target as external and allow the request. The defect is in the parse gate rather than in any one classifier, so every consumer of Address4 inherits it: isPrivate(), isLoopback(), isLinkLocal(), isCGNAT(), isInSubnet(), isHostInSubnet(), and correctForm() are all computed from the mis-decoded octets. This issue is fixed in version 10.3.1. | 2026-08-03 |